top of page

Support Forum

Public·1140 members

sourabh meenasourabh meena
sourabh meena

AudioMoth v1.2.0 – Waterproof Case Compatibility with External Contact Microphones

Hello, we are based in Germany and would like to use external contact microphones with our AudioMoth v1.2.0 devices. However, installing the 3.5 mm jack makes the IPX7 waterproof case incompatible. Could you kindly suggest a suitable solution? Thank you for your help!

125 Views

Hi Sourabh,


The AudioMoth Dev has an inbuilt 3.5mm jack and the corresponding AudioMoth Dev Case has an M16 hole in the base that is intended to be used with a cable gland to allow hydrophone and microphone cables to pass through it.




This also makes it easy to use the GPS board for synchronised recording or time setting, and also use the external electret capsule microphone.


If you use the standard AudioMoth, you can place it inside an small off-the-shelf electronics enclosure and use the same cable gland to seal the enclosure. For short deployments it would also be possible to deploy in a vacuum or freezer bag with the cable sealed with tape.


Alex

Editado

Support Forum

©2026 Open Acoustic Devices

bottom of page