No LED's light up when setting to CUSTOM
This problem concerns 2 particular Audiomoths that I check up regularly to change only the sd cards, i turn them off, take it out, put in a new one, put it on DEFAULT to check that its recording to the sd card properly, if so, put it on CUSTOM and finally check that its idling like expected as its most probably outside the established recording time.
However, the last time I did this, when I set the switch to CUSTOM, no lights light up at any point.
In principle this would mean that the batteries have gone flat, however when I first set it to DEFAULT to check the sd card write, the red LED blinks as expected, showing that it is actually taking a recording, to troubleshoot, I then take out the sd card and the blinking pattern reflects that it detects nothing to write to, take the batteries out and back in and set the time back with the phone app, but all the same, no lights when setting to CUSTOM.
I'll say that its deployed for well over a month, however, in doing the regular checkups to get the data, I also check the behavoir of the batteries every time using the "summarise audiomoth files" function of the audiomoth configuration app, which shows they have never gone under 4.5 volts, which to my understanding shouldnt be in the range of "low battery" yet.
Hi,
This is a strange failure. Does the green LED light when plugged into USB and in USB/OFF? If not, possibly the LED has failed.
Can you share the CONFIG.TXT file from the device?
Alex