Hi,
I trying to flash firmware for AudioMoth following instructions in AudioMoth Manual.pdf but I have some problems.
When a try flash the firmware in the audiomoth whit the “flash app” no audiomoth is found.

When I run the flash executable by typing in the command window “flash. exe”, only one port (COM3) appear.
When I attach the audiomoth in my computer via USB, the LED’s not flashing.
When I I run the flash executable by typing in the command window “flash. exe”, now with the audiomoth connected only one port (COM3) appear.
Is not the cable, because is working with others audiomoth.

Any suggestion for this error, can you help me please.
Paulo Barros
That's strange. Are you sure the batteries are good and are the right way round?
The Time App, Flash App and Config App will potentially get confused if more than one are open at the same time as they are all talking to the same USB device. I don't think that is the issue here but just in case, make sure that you only have one of the apps open at a time.
I got through the audiomoth in flash mode and install the firmware, but a strange thing is happened.
The audiomoth with batteries in mode USB (but not connected to the laptop), the green leds are on continuously .
When I put the batteries in the audiomonth to configure then by the Configuration APP, my Laptop don´t recognizing the audiomoth.
But if I connect the audiomoth to the pc whithout baterry, recognize it and I can configure audiomoth.
Can you try the manual approach to putting the device into flash mode on one of the other devices. It's a bit fiddly - without batteries, you need to plug in the USB whilst the paper clip is held on the contacts. That will always recover a device back into flash mode. Practice on one that you know is working correctly, so that you are confident that this process works, and then it try on the one that is causing problems.
Yes, I