Please, also there is a difference in the time of delivery of the older version 1.1.0?

Hi, I would like to inform about the delivery time when I would buy some 40 devices from Labmaker. Our project will start at the end of April and we would need them between the end of March and the beginning of April. The destination country is Austria. Thank you.

OK, thank you.

No there is no recording on the card. It was weird because I used three SD cards, by two both LED were flashing and by another one red light was shining and green was flashing for 1 s interval. However, there were no recordings.

My fault, I forget to insert SD card. Now, in DEFAULT mode the red light is shining and green is flashing in 1 s interval.

Hi, I have tried to check this device again. I put batteries to Audiomoth with Default mode. Both flash lights are flashing in short interval. When I switch to another setting then flashing is off. And also when I return to Default then LEDs are not flashing. When I connect it to PC it looks like that this device is not communicate with the app. So, is there something new what I should try to do?

Ok, I applied you advice and it is ok, now. Thank you!

Hi, I had the same problem. I am also using Linux Mint. Please guys share the solution here.

My laptop resolution is 1366x768.

Hi, I downloaded this app but I cannot resize the app window to smaller one. I have Linux Mint on laptop. So it is very hard to use it in the field.

Please it is ok that there are some scratches on the gold contacts in the left lower corner?

Another image

I attach a picture however there is lost something? I cleared the surface of battery connectors.

I applied your advance. However nothing change. The LED is not flashing and I cannot see the device via PC.

Ok, I try it tomorrow because I am out of my home. I let you know result.

It comes from second or third round. Firmware was updated by myself. Did you think that I should update the firmware?

Ok, I tried it. So the redlight didn't flashing. It looks like problem in power supply. On the SD card is nothing recorded.

Hi, I am using probably the newest firmware. The config app is also the updated version. However I cannot confirm it because the app and the device don't communicate each other. How I wrote the LED don't flash. Result is that I can't connect the AM with PC.

Hi, I add my vote for the android app. In the field it is not very practical to bear a laptop. Smartphone is a much more better alternative.

I checked it and the app is working well! Now it is ok. Thank you again.