©2019 Open Acoustic Devices

martin
Jan 27, 2019

Problem Flashing AM Firmware

Trying to flash latest firmware for AudioMoth following instructions in AudioMoth Manual.pdf but keep getting cmd.exe/flash.exe error "incorrect arguments" ? Could this be the downloaded .bin file name Audiomoth1.2.0.bin with all those dots ?

Martin

2 comments3 replies
Alex Rogers
Jan 27, 2019

Can you share exactly what you are typing into the command line, or post a screenshot.

0
martin
Jan 27, 2019

Hi Alex, herewith screenshot as requested !

Hope this helps !

0
Alex Rogers
Jan 27, 2019

You need the '-u' option as per the summary -


flash.exe -u COM3 AudioMoth1.2.0.bin


An earlier version of flash didn't need '-u' but we changed it to make it more consistent.

0
martin
Jan 27, 2019

Brilliant ! That fixed it. Not very familiar with cmd.exe etc., so didn't appreciate the error messages properly. However, the screen shot in the AudioMoth Manual doesn't show the "-u" switch, perhaps this needs a look at ?

Thanks again for your fantastic support !

Regards

Martin

0
New Posts
  • Vijay Ramesh
    26 minutes ago

    Rechargeable batteries?

    Question 
    I have seen two posts on this forum regarding rechargeable batteries. I am currently thinking about investing in purchasing 1.2V Envee 2800mAH rechargeable batteries, as I will be creating much lesser electronic waste compared to purchasing regular alkaline batteries. Apart from operating at the lowest threshold for the Audiomoth's, has anyone used rechargeable batteries for a while now? How does it affect the performance? Did you have to replace them every few days? Any issues with writing data to the SD Card?
  • adria.baucells
    3 days ago

    Hardware v.1.1.0

    Question 
    Hi! I was wondering if you have made available the design and hardware for the audiomoths v.1.1.0. Also, I would like to know if you have a doc specifying the technical differences and improvements between Audiomoth v.1.0.0 and v.1.1.0 Thanks in advance! And congrats for such a lovely project!
  • Fred Adam
    3 days ago

    analyzing process tutorials ?

    Question 
    Hello community, i am new to this world, i come from fine arts and in need some advice to take advantage of the Audiomoth. I would like to 1- auto select frequency patterns on the spectrogram for the counting of the call of certain animals on long recordings, not sure what sound editor i can use for this (for example counting the call of the frog 45 times in one hour). 2- I don't understand how i can visualize the full frequency spectrum of a 96 khz or more on a regular audio editor like Audition. It seems that the interface only shows until 44khz. 3- What is the best method to listen to more than 20 khz inaudible sounds ?..pitch /slow down... ? thanks!
Before posting, be sure to check the FAQ.