To test this feature, visit your live site.

Micro Moth

When configured properly will the Micro Moth green LED blink when ready to be deployed? If not I have configured and when I disconnect micro moth from USB the green LED stops flashing.

2 comments

2 Comments

Alex Rogers

Mar 11

Hi, You need to switch the MicroMoth to CUSTOM or DEFAULT to start recording. DEFAULT will make a continuous recording and CUSTOM will follow the configured configuration. The switch is in the corner of the PCB and is actuated with a small screwdriver. Alex

Alex Rogers

Mar 11

Replying to

Also double check the polarity of the battery you are using. There is no standard so you may have to swap over the crimp connectors inside the plastic housing. There is normally a small plastic clip holding each crimp connector into the plastic housing. The PCB is marked with plus and minus to mark the polarity.