AudioMoth 1.0.0 not recognized with firmware 1.4.4

in Device Support

My AudioMoth 1.0.0 worked with firmware 1.2.1

I upgrade to the last 1.4.4 using "Follow instructions to manually switch to flash mode"

and everything goes fine.

Nevertheless, Once I start AudioMoth-Config 1.3.6, the unit is no longer recognized,

despite I get the familiar usb sound at connecting and disconnecting the usb cable.

Also, If I start AudioMoth Flah App again, it claims no AudioMoth device is found.

Other units 1.0.0 and 1.1.0 with firmware 1.2.1 keep working with AudioMoth-Config 1.3.6,

despite the initial message (just do not use the newer features).

1 answer2 replies

3 Comments

Share Your ThoughtsSign up to leave a comment.

Andy

Sep 15, 2020

Hi Agustin,

Are all the apps open at the same time?

Could you try unplugging AudioMoth and closing all AudioMoth apps? Then with all apps closed open only the Configuration App. Does AudioMoth connect?

Let us know if this solves the issue.

Andy

Agustin Lobo

Sep 20, 2020

Replying to

I apologize for my late reply, but I was expecting a notification email as it is noted that I'm following the issue.

I was using only 1 app at the time. I've done as you indicate, same problem. The LED is green but neither app is aware of the unit being connected, despite the familiar USB sound when I connect and disconnect the unit.

I'm reluctant to try upgrading the rest of my units...

What I've done is flashing again with firmware 1.2.1 and it works again with this old version. I will try upgrading to 1.2.2 and, if it works, will continue step by step, and will report back.

Agustin Lobo

Oct 04, 2020

Replying to

Moved to https://www.openacousticdevices.info/support/flashing-support/no-audiomoth-found-after-updating-from-1-3-0-to-1-4-0

AudioMoth 1.0.0 not recognized with firmware 1.4.4

Before posting, be sure to check the FAQ.