©2019 Open Acoustic Devices

lyndon.roberts
Jul 28, 2018

Firmware load error

4 comments

Hi, I am trying to initialise my AudioMoth using Windows 10, but I keep getting an error "Could not open file" at the final stage when I enter "flash.exe COM4 Audiomoth.bin" in the command line. Any ideas?

 

Peter Prince
Jul 30, 2018

Hi there,

Have you made sure that AudioMoth.bin is in the same directory as flash.exe?

Peter

0
lyndon.roberts
Jul 30, 2018Edited: Jul 31, 2018

Yes I have. But I have just noticed that the downloaded firmware is in a file named AudioMoth1.1.0.bin, not AudioMoth.bin.

So ... I'm guessing that it's a simple mismatch of filenames and I either have to rename the file or modify the command?

0
andypwilkinson
Jul 31, 2018

Hello Lyndon,

I was having the same problems as yo. I got the correct firmware download functioning when I renamed the .bin file. I changed mine to AudioMoth.bin from AudioMoth.1.1.0.bin

0
New Posts
  • gazlang
    Nov 29

    App downloads not working

    Hi, I've just received my audiomoth, but can't download the config app. I get the following response when clicking the download link: This site can’t provide a secure connection github-production-release-asset-2e65be.s3.amazonaws.com sent an invalid response. Can anyone look into this? Thanks
  • Sameer Saxena
    3 days ago

    Different Settings

    I was trying to implement a setting where i can just record bats and no other animals like crickets(insect) and all. Is there a possible way to change it in the firmware?
  • Morgan Hughes
    Nov 25

    Help with recognising audiomoths

    Hello, I have been lent two audiomoths by my phd supervisor for my study. I have followed all setup instructions and when I run the configuration, the time does not go black, but remains greyed out. Having searched through this forum, I thought it might have been a USB issue, so I purchased a usb data cable specifically. No dice, I'm afraid. I thought perhaps they are old and needed new firmware, and I have successfully flashed both devices with 1.2.2. The configuration app is still not recognising the units when I plug them in. I have been through the instructions meticulously. Any ideas on what I'm doing wrong? (Presumably this is a user error since it is happening to both units?) Thanks!
Before posting, be sure to check the FAQ.