top of page
Forum Posts
p.wrege
Nov 30, 2017
In Device Support
What is the lower voltage level where recording will stop? I seem to have some performance trials that are stopping at about 3V (under load), but will record in default mode at this voltage for awhile.
0
5
289
p.wrege
Nov 18, 2017
In Device Support
Just got my trial AudioMoths and don't understand the LED flashes that I am getting. I double-checked the configuration and this seems fine (8kHz sampling rate, schedule 00:00 to 23:59, gain 'low'). - one unit is flashing green every 2 seconds for 7 repeats, then a quick long green flash. This appears to be signaling a full micro-SD. I reformatted and it is behaving like the one below. - one unit is flashing red at a similar interval, then after 5 repeats a short green flash and a pause of about 4sec, then red again. if this one is switched to 'default' it resumes the same flashing sequence as above. It would be good to update the 'getting started' with a full description of LED status indicators.
0
18
1k
p.wrege
More actions
bottom of page