Forum Posts

damien
Jun 01, 2021
In Device Support
Hello, So I upgraded to firmware 1.6, but now I have another issue. The recordings are almost inaudible. Even if I speak loudly close to the audiomoth. It is not related to the upgrading to firmware 1.6 as this issue appeared 2 or 3 days ago before I upgrade the firmware. What can be wrong ? I use the same settings as before (sample rate 48, gain Medium). Is my mic fried? Thank you.
0
4
72
damien
May 31, 2021
In Device Support
Hello, I tried to upgrade firmware to the latest 1.6, my audiomoth was recognized (Manjaro Linux), I downloaded the 1.6 firmware, tried to upgrade, but it failed. When I tried to upgrade again (I unplugged the audiomoth, then plugged it in), my audiomoth was not detected. If I try to record with the switch on default or custom, nothing, no lights. Batteries are new, sd card was working fine just before. Thank you for any suggestions.
0
2
53
damien
Apr 27, 2021
In Device Support
Hello, I just flashed the 1.5.0 firmware and now I end up with a single big file when I switch to default or custom recording. My config says: Sleep duration (s) : 5 Recording duration (s) : 55 Thank you for any suggestions.
0
3
53
damien
Apr 25, 2021
In Device Support
Hello, My audiomoth don't connect anymore to my computer (Linux Manjaro Xfce). I wanted to upgrade to the latest firmware, 1.5. So I launched the flash app, switch the audiomoth to usb mode. It recognized the audiomoth. I downloaded the 1.5. firmware from the app, then tried to flash it. It began the flashing process but after a while I had an error message saying something like it can't open ports... And now, when I retry, it can't even detect the audiomoth. I, of course, followed the "additional linux installation notes" before doing all this, except for "sudo usermod -a -G dialout MY_USER_NAME" which returned: "usermod: group 'dialout' does not exist". Thank you for any help.
0
2
60
damien
Apr 23, 2021
In Device Support
Hello, Is it possible to have different sample rates in the same config file? I wish to be able to record birds manually at 48khz (switch on default) and record bats at 256khz (switch on custom) for scheduled recordings. Thank you.
0
2
47
damien
Oct 11, 2020
In Device Support
Hello, Does it mean I have to change the batteries? All the recorded files are 488 Bytes in size. Thank you.
Recording cancelled due to low voltage content media
0
0
39
damien
Jun 05, 2020
In Flashing support
Hello, I am trying to flash my audiomoth 1.10 with firmware 1.4.0 I am with Linux Mint 18.3. I had to follow (successffully) the paper clip procedure but when I try to flash I receive an error message (please, see screenshot below): The audiomoth is connected. I tried several times but no success. Thank you for any help.
0
7
117
damien
Nov 16, 2019
In Configuration Support
Hello, I used to record birds (video+sound) as a hobby in my garden using a raspberry pi computer (+ a camera and a microphone attached to the Pi) and a motion detection software. I stumbled upon the audiomoth, ordered one and I wish to record birds for now. What set up should I use? Any advises welcome... Thank you.
0
6
127
damien
More actions