Dev Case with External Microphone and Holder – still waterproof?
Hello, We are setting up five AudioMoth Dev units in Dev Cases for bat and bird monitoring outdoors, left unattended for about a month at a time. One unit will get the External Microphone and Holder (Primo EM419N) for a side-by-side microphone comparison, powered by 3 D cells inside the case. Two questions: 1. With the microphone holder fitted in place of the M16 cap, is the Dev Case still waterproof (IPX7), or does it need extra sealing? Our reseller told us that fitting the external microphone removes the waterproofing. 2. Does anyone have experience with 3 alkaline D cells in the Dev Case holder: how long did they last at 384 kHz with a duty cycle, and in frost? Thank you in advance, Liselotte
315 Views
Hi Liselotte,
Yes, the microphone mount has an acoustic vent covering the opening. You can unscrew the end cover of the microphone mount to reveal the acoustic vent and two spare vents are included in the pack. Make sure that the rubber o-ring is on the outside of the housing and tighten the M16 nut to compress it.
The duration will depend on the sample rate. Good alkaline D-cell batteries will have a capacity of about 10,000 mAh. If you record at 384 kHz continuously, you will use 580 mAh per day, so you'll have about 17 days of continuous recording. Recording at night or duty cycling will increase the deployment time proportionally to the time spent recording. The Config App will do this calculation for you.
The energy consumption varies very significantly with the choice of SD card. We recommend SanDisk Extreme 32GB and 64GB cards, and Kingston Canvas Select Plus for longer deployments. The application note below shows a comparison of different cards: https://github.com/OpenAcousticDevices/Application-Notes/blob/master/A_Comparison_of_SD_Card_Energy_Consumption/A_Comparison_of_SD_Card_Energy_Consumption.pdf
The external microphone is less sensitive than the internal MEMS at high frequencies. But more sensitive at low frequencies. We would typically use it for long term bird recording deployments as the wind shield helps protect the microphone, but it is less suitable for recording bats.
https://github.com/OpenAcousticDevices/Application-Notes/blob/master/An_External_Electret_Microphone_for_AudioMoth/An_External_Electret_Microphone_for_AudioMoth.pdf
Alex